The Wizard

<< Click to Display Table of Contents >>

Navigation:  PlantSpecDriven > How to use > Configuration >

The Wizard

Previous pageReturn to chapter overviewNext page

This chapter describes how to setup PlantSpecDriven by using the Wizard.

In general there are two types of setups. Spec Driven setup for P&ID Lines, P&ID Line Groups, P&ID Symbols and the Link to 3D. And Non-Spec-Driven setup for Equipment and Nozzles.

Table of Content:

Main Dialog

 User Interface

 Creating a link configuration

 Editing a link configuration

 Deleting a link configuration

 Importing a link configuration

 Refreshing link configurations

Spec Driven - Lines & Symbols

 Page 1 - Link Type

 Page 2 - Pipe Spec Template

 Page 3 - Class Selection P&ID

 Page 4 - Pipe Spec Table

 Page 5 - Linked Fields

 Page 6 - Mapped Fields

 Page 7 - Mapped Ports

 Page 8 - Column Order

 Page 9 - Thumbnail Images

 Page 10 - Miscellaneous Settings

 Page 11 - Special Symbols

 Page 12 - Assign Catalog - Port Properties

 Page 13 - AutoPipe - Flanges

 Page 14 - AutoPipe - Fasteners

 Page 15 - P&ID <--> 3D Mapping

 Page 16 - AttributeFlow

 Page 17 - Link Configuration Name

 Check

Non-Spec Driven - Equipment

 Page 1 - Link Type

 Page 2 - Class Selection P&ID

 Page 3 - Class Selection 3D

 Page 4 - P&ID <--> 3D Mapping

 Page 5 - Link Configuration Name

 Check

Non-Spec Driven - Nozzle

 Page 1 - Link Type

 Page 2 - Class Selection P&ID

 Page 3 - Class Selection 3D

 Page 4 - P&ID <--> 3D Mapping

 Page 5 - Link Configuration Name

 Check