Non-Spec Driven - Equipment

<< Click to Display Table of Contents >>

Navigation:  PlantSpecDriven > How to use > Configuration > The Wizard >

Non-Spec Driven - Equipment

Previous pageReturn to chapter overviewNext page

This chapter describes the setup in the Wizard if you want to link your P&ID and 3D Equipment. Linking Equipment is optional.

If you want to link Nozzles too, you must setup the Wizard for Equipment first.

You can have only two Non-Spec Driven configuration in your project. One for Equipment and optional one for the Nozzles. Nozzles are described under Non-Spec Driven - Nozzle.

Table of Content:

Page 1 - Link Type

Page 2 - Class Selection P&ID

Page 3 - Class Selection 3D

Page 4 - P&ID <--> 3D Mapping

Page 5 - Link Configuration Name

Check