Solving Inconsistencies (P&ID/3D)

<< Click to Display Table of Contents >>

Navigation:  PlantSpecDriven > How to use > Use Cases > Linking Equipment and Nozzles (3D) >

Solving Inconsistencies (P&ID/3D)

Previous pageReturn to chapter overviewNext page

This chapter describes how to solve inconsistencies between linked Equipment and Nozzles.

The descriptions in this chapter are the same as in Solving Inconsistencies (P&ID/3D).

We start by changing the Tag of the P&ID Equipment.

Use Cases 0425

We see the change in the Tag on the symbols, but also in the Structure Tree. In addition, we see the cyan dot indicating an existing inconsistency.

Use Cases 0426

 

Use Cases 0427

We use Show inconsistencies to see the differences between P&ID and 3D.

Use Cases 0428

We can use Copy P&ID to 3D to copy the value over to 3D.

Use Cases 0429

Now the inconsistency is gone.

Use Cases 0430

The Structure Tree shows green.

Use Cases 0431

And the Tag in 3D shows the changed value too.

Use Cases 0432

Next Chapter: Unlinking Equipment and Nozzles (3D)