Spec Driven - Lines & Symbols

<< Click to Display Table of Contents >>

Navigation:  PlantSpecDriven > How to use > Configuration > The Wizard >

Spec Driven - Lines & Symbols

Previous pageReturn to chapter overviewNext page

This chapter describes the setup in the Wizard if you want to link your P&ID Line Groups, Line Segment, Inline Assets, and Inline Instruments.

Before starting the Wizard make sure that you already setup a Pipe Spec and made the necessary changes to P&ID Properties, 3D Properties, P&ID Classes & Symbols.

Remark: As mentioned earlier we use the term Assign Catalog Data, but it should actually be Assign Pipe Spec Data, because PlantSpecDriven assigns data from the pipe specs and not the pipe catalogs.

Table of Content:

Page 1 - Link Type

Page 2 - Pipe Spec Template

Page 3 - Class Selection P&ID

Page 4 - Pipe Spec Table

Page 5 - Linked Fields

Page 6 - Mapped Fields

Page 7 - Mapped Ports

Page 8 - Column Order

Page 9 - Thumbnail Images

Page 10 - Miscellaneous Settings

Page 11 - Special Symbols

Page 12 - Assign Catalog - Port Properties

Page 13 - AutoPipe - Flanges

Page 14 - AutoPipe - Fasteners

Page 15 - P&ID <--> 3D Mapping

Page 16 - AttributeFlow

Page 17 - Link Configuration Name

Check